OEM Keyless Entry Remote Fob for Mercury Villager & Nissan Quest GQ43VT8T

Description

Used Keyless Entry Remote for Nissan Quest / Mercury Villager
FCC ID:
GQ43VT8T
Buttons:
3 (Lock, Unlock & Panic)
Functional condition:
New battery installed, all buttons tested to output good signal
Cosmetic condition:
Normal wear to exterior case, and varying degrees of wear to button labels.
If you'd like to see a photo of the actual remote(s) you will receive, contact me before buying.
Compatibility
Programming
Compatible with all vehicles in the list above,
as long as the vehicle is equipped with factory keyless entry.
Before buying, try the programming procedure to the right to verify your van is equipped with factory keyless entry.
1. Enter vehicle, close and lock all doors using power lock switch on drivers door.
2. Insert and remove (do not turn) key from ignition at least 6 times within 10 seconds. Tail lamps will flash to indicate original code has been erased.
3. Insert and turn key to ACC position.
4. Press LOCK on first keyless remote. Tail lamps will flash to confirm programming.
5. To add additional remotes, unlock then lock the doors using power lock switch on drivers door.
6. Press LOCK button on second keyless remote. Tail lamps will flash to confirm programming.
7. Open drivers door, turn ignition to OFF.